舞台灯激光灯红绿激光灯圣诞节满天星激光灯多图案舞台灯

配  件 

1．激光灯1台  2.交流适配器1个  3.说明书1份 4.三脚架1个

规  格 

＊电源:交流适配器输入AC110-240V/50-60HZ，输出5.0V/1A

＊激光图形:满天星(红+绿)

＊波长/功率:532nm/50mW(绿)，650nm/100mW(红)

＊尺寸:109x87x135.2mm

注意事项 

1.严格按本操作说明书所述规程操作,请勿擅自拆卸灯具。

2.本产品仅适用于室内使用,并确保防水、防潮、防震，勿在多尘环境中使用。

3.于半导体激光器特性,要求工作环境温度为15~30℃，连续工作两个小时候后,需关闭灯具10分钟,激光器会完全冷却。

4.防止异物进入机体内,以免导致故障。

5.请勿频繁开关,以免影响激光灯使用寿命,并尽避免长时间开启。

6.避免用远望设备观察激光光源,这样可能增大危险。

7.再次运输时,请注意防震,好使用原包装。

* 告

1.本灯具激光危险等级为Class III B,直接在光束内观察有危险。

2.该灯具对电源要求110-240V/50-60HZ，若超出此范围,建议使用稳压设备,否则将严重影响激光寿命。

声  明

  本产品在出厂时己经过全面严格的检测，使用者应严格遵守以上所陈述的*告事项和操作说明，任何因误用而导致对产品的损坏不在本公司保修范围之内,对忽视操作手册而导致的故障和问题亦不在经销商负责的范围内，任何操作产生的激光对人体损害，本公司不负责任。

Fittings
1. Laser light 1 set 2. AC adapter 1 3. Manual 1 4. Tripod 1

Specifications
* Power: AC adapter input AC110-240V/50-60HZ, output 5.0V/1A
* Laser graphics: stars (red + green)
* Wavelength / Power: 532nm/50mW (green), 650nm/100mW (red)
* Size: 109x87x135.2mm
 
Notes
1. In strict accordance with procedures described in the instruction manual operation, do not disassemble lamps.
2. This product is only suitable for indoor use, and to ensure that water, moisture, shock, do not use in dusty environments.
3. Based on semiconductor lasers, the working environment required temperature 15 ~ 30℃, continuous two hours later, take off lights for 10 minutes, the laser will cool down completely.
4. To prevent foreign matter into the body, so as not to cause trouble.
5. Please do not often switch, so as not to affect the life of the laser light and to avoid prolonged open.
6. Avoid afar observe laser light source device, which may increase the risk.
7. Again transport, please note that earthquake, it is best to use the original packaging.
 
Warning
1. The laser light risk rating for the Class III B, to observe directly in the beam is dangerous.
2. The lights on the power requirements 110-240V/50-60HZ, if out of this range, it is recommended to use voltage regulator device, otherwise it will seriously affect the laser life.
 
Statement
   This product has been fully rigorous factory testing, the user should strictly comply with the above stated warnings and operating instructions, due to misuse of any product damage caused is not within the scope of our warranty, instruction manual and on the neglect of failures and problems are not caused by the dealer within the responsibility of any action on the human body generated by the laser damage, the company responsible.